
Plumbing/Drainage Fittings


The O’ring Adaptor is designed to allow for ground movement
relative to the house downpipe.
(a) Overcomes the two fixed points struggle
(b) Overcomes reactive soil movement
Assemble downpipe,
Slip on O-Ring Adaptor - use o-ring lubricant
1. Place downpipe into drain,
2. Up to gutter drop,
3. Fix brackets,
4. Glue joint and slip into drain.
Tested to 3m head for tank jobs.
Can accommodate about 5˚ misalignment
Take care - there are no scratches on the 90 D/P at O-Ring seal.
Where this joint is underground, tape it to prevent particle entry to O-Ring area.
This fitting allows for ground movement relative to the house



The Drainmaster was designed to overcome the difficulties Plumbers and Drainers
experience with conventional stormwater pits. Not being able to achieve satisfactory surface finish height, Concreters and Landscapers often called
upon the Plumber or Drainer to extend or lower the grate height. With the Drainmaster, it is a simple cut and glue procedure using PVC Weld cement, at the time when the Concreter and Landscaper is finishing off.
The Large inlet grate maximises water drain efficiency. It is designed for
pedestrian traffic and has a strong grate and body with four internal pillar supports.
At 225mm X 225mm square, it sits about 85 mm deep when cut off for use with 100mm pipe, or about 115 mm deep when used with 90mm pipe. It can be used for shallow pipes simply by connecting a 90 degree X 90mm stormwater elbow to connect your pipe. It has been designed to fit into a few different pipe sizes and types which are:
1. 100mm Agy-pipe
2. 100mm Stormflex
3. 100mm PVC Pipe
4. 90mm Stormwater Pipe



The female flex Adaptor fits 90mm stormwater pipe directly to stormflex.
She is great for 90mm downpipes going into storm flex drains.
When the brickie cuts your Stormflex or the bobcat crushes it she will
join up with the male flex adaptor for easy stormflex repairs.
She is definitely a handy fitting to have from time to time.

The Male Flex Adaptor has been designed to provide an easy
to use adaptor to connect Stormflex type pipe to any 90mm s/w
fitting as well as inside any 100mm dwv pipe.
You now have one fitting made for both 90mm and 100mm connections
Makes using Flexible stormwater pipe so simple.
It saves you Time and Money!!!


Can be fitted at floor level for safety. (No trip) Solvent weld
No need to remove plugs to install Termimesh barriers
Remember when air testing to 4PSI, we recommend 2-3 hrs
solvent cure time - cut upstand pipes and fit plugs at start
of job to get maximum weld strength.





Can be fitted at floor level for safety. (No trip) Solvent weld
No need to remove plugs to install Termimesh barriers
Remember when air testing to 4PSI, we recommend 2-3 hrs
solvent cure time - cut upstand pipes and fit plugs at start
of job to get maximum weld strength.




Can be fitted at floor level for safety. (No trip) Solvent weld
No need to remove plugs to install Termimesh barriers
Remember when air testing to 4PSI, we recommend 2-3 hrs
solvent cure time - cut upstand pipes and fit plugs at start
of job to get maximum weld strength.
