Plumbing/Drainage Fittings

Makes Grate Connections

Easy to install with just 2 s/s screws (supplied) to suit the following pipes:

 

100 DWV Pipe - screw to (outside holes)

90mm SW Pipe - screw to (inside holes)

100 Agy Pipe - screw to (inside holes)

100 Stormflex Pipe - screw to (inside holes)

 

Keeps the frogs out of your pipes.

 

To clean access, just undo the 2 screws to remove the entire 

grate, which gives you full access to the pipe.

 
 

The Temporary Down Pipe is the time efficient and cost effective answer to council requirements for environment protection sediment and erosion control - under pollution from building sites.

 

This popular product increases production efficiency and safety

for all trade aspects working in wet conditions.

 

The downpipe comes as a plastic lay flat tube that measures

about 200mm across, and comes in 170m or 17 lengths.

 

TPD is also available to suit 150 mm downpipes.

 

Suggested fixing method:

1. At the downpipe drop in the gutter - roll your TDP over about 3 times like you would for the top 

of your socks. Slip it up over the drop and put 2 screws through the rolled TDP into the drop.

2. At the stormwater pipe end you can insert a short piece of the same pipe which has 

    been slit so you can compress it inside the TDP water pipe to hold it open at that point. 

    One screw through should secure.

3. Alternatively a lot of builders now fix it in place using duct tape on both ends.

The 120mm X 200mm (large) Cupboard Plate may be used as a patch, or drilled to

 suit your needs, e.g., spa pumps, vanity basin services etc.

 

You’ll never get caught on the job without the right size cupboard plate again.

Cupboard plates can be knocked out over 50mm pipe & peeled out to 

accommodate the following sizes.

 

- 40mm DWV Pipe and 40mm Socket

- 50mm DWV Pipe and 50mm Socket

 
 

The 120mm Round (small) Cupboard Plate may be used as a patch, or drilled to suit your needs, e.g., spa pumps, vanity basin services, etc.

 

You’ll never get caught on the job without

the right size cupboard plate again. 

 

Cupboard plates can be knocked out over 50mm pipe

& peeled out to accommodate the following sizes.

 

- 40mm DWV Pipe and 40mm Socket

- 50mm DWV Pipe and 50mm Socket

 

BSP x 100 x Recess 12mm makes a tidy finish

when your 19 BP is short.

 

Use centre plug in 19BP to guide 57mm holesaw.

 

The Smart-Ass is a cover plate for dishwasher hoses and power 

leads in cupboards at wall penetrations.